Zicome 20 Cavity Silicone Pink Lolly Pop Party Cupcake Baking Mold Cake Pop Stick Mold Tray - Read the Warming Tips Before Starting Your Cake Pops Making

Description

ZICOME SILICONE CAKE POPS LOLLIPOPS MOLD INSTRUCTIONS
1. Use a good cooking spray and really spray them liberally, then check it to be sure that none were missed. This is the easiest way to get it done. Using sprays shortening or Crisco oil would take a lot of time. Just be patient and careful and you will not have any problem with them poping out.
2. Fill with batter to almost the top of the bottom indentations; less than that and your cake pop will have a flat top; more than that and your cake pops will ooze into each other. But Different batters will raise differently so that you should make one tray to figure out how much they needed to bake.
3. Baking time will depend on batter, you should also try one to figure out how long they needed to bake, but in terms of 12-21 minutes and then check one of the center molds to make sure.
4. Right after removing from the oven carefully remove the top mold. If you don t, your popcake balls will get mushy from steam.Be careful because of the hot steam
5. Set the bottom mold on a cooling rack and let it cool off for a few short 10-15 minutes.Wait too long and they ll stick to the mold.
6. After removing from mold let them cool off the rest of the way. Then in a single layer on a cookie sheet put in freezer till very firm. If you were going to coat them with chocolate right away they ll be firm enough to get started. If not after they are frozen stick all the balls in a freezer bag then you can take out just the amount you need. When defrosting remove them from the plastic freezer bag or the condensation will make them wet and mushy.
7. Clean up is easy. All you need to wash the molds is some warm soapy water. Takes just a few seconds and they are clean and ready for the next cakeball party.:)