YIKESHU 4 wheel 2 layer Robot Smart Car Chassis Kits with Speed Encoder for Arduino DIY (4 Wheels)

Description

Couleur:4WD
Installation steps:
STEP 1: Insert the fastener into hte chassis after tearing off the yellow protection wrap of the chassis,the fastener and the code wheel
STEP 2: Install the code wheel and fix the motor to the chassis .(Attention,the copper sheet of the leading wire of the motor should face outward,the same side of the wheel)
STEP 3: Fix the motor to the chassis ,then insert and tighten the screws.
STEP 4: Insert the screws and fix the battery container.
STEP 5: Insert the spacer and tighten the 8 screws to fix the hammer caster.Hold tight and insert the motor(protection fastener) to the wheel .
Description:
Intelligent car chassis tracing car Robot car chassis with code disk
Ideal for DIY
This car is the tachometer encoder
With a 4 AA battery box and power switch. (Batteries not included.)
Can be used for distance measurement, velocity.
Can use with other devices to realize function of tracing, obstacle avoidance, distance testing, speed testing, wireless remote control.
Package Included:
2 x Car chassis
4 x Gear Motor (1:48)
4x Speed encoder
8x Fasteners
Screw