SunFounder 250 FPV Quadcopter Drone Frame Kit CC3D EMAX ESC Simon 12A Motor MT2204 Glass Fiber Racing Flying 4-Axis Propellers Battery Balance Charger for Lumenier QAV250 ZMR250

Description

Note:
The remote control and its receiver are not included.

Introduction
The realization of FPV flying starts from having a SunFounder 250 aircraft. The SunFounder 250 Quadcopter is tailored for the hobbyists for FPV flying. It features stability, flexibility and activity. You can realize a stable flight in a high or low altitude or in a forest with the SunFounder 250. The skid landing damping sponge tubes bound onto the motors help stablize the flight and protect the frame through increasing the buffer between the frame and the land when the aircraft is landing.
It runs the OpenPilot firmware of the flight controller firmware and the 12A EMAX brushless electronic speed controller. This kit is designed to meet the hobbyists higher requirement of flying the aircraft. You can realize a stable flight in a small space or a rapid 3D flight based on your own configuration and parameter setting.
The Image Transceiver Kit is available on http://www.amazon.com/dp/B01MCT9K5E
For the FPV TFT LCD, you are recommended to this link: https://www.amazon.com/dp/B01LXZAP8M
Get the Carbon Fiber version at https://www.amazon.com/dp/B01M3T5YZF

Package included
1 x Quadcopter Frame (set)
4 x EMAX CW /CCW Motor
1 x Balance Charger
1 x Battery Indicator
1 x Power Adapter
4 x EMAX ESC
1 x Li-Po Battery
4 x CW/ CCW Propellers
1 x CC3D Flight Controller
1 x Adapter Cable
1 x USB Cable
1 x Heat Shrink Tubing
5 x 3M glue
20x Nnylon Zip Ties
4 x Damping pipe
24x Banana Bullet Connector
1 x Damping plate (set)
1 x Section Board
1 x Lashing
1 x Allen Wrench
1 x Velcro Tape