Signswise 600p/r Incremental Rotary Encoder Dc5-24v Wide Voltage Power Supply 6mm Shaft

Description

Suitable for a variety of intelligent control displacement measurement ,automatic fixed-length automatic guillotine paper machine,steel cut length control ,civilian measured height human scale,students racing robots.

Specification

Encoder size: 39 x 35.5mm,Shaft 6 x 13mm
Axis stopper platform: High 5mm, 20mm
Fixed empty as: three 3mm screw holes distribution of 120 degrees / or six 3MM screw holes into 60 degree distribution,to the center distance of 14mm.
Wires length: 188cm / 74"

Detail

Color: Like the picture show
Model: incremental rotary encoders,AB two phases
600P/R-600 pulses per revolution.
DC 5-24V power supply.
Maximum mechanical speed of 6000 rev / min.
The response frequency: 0-20KHz

Output

AB two -phase quadrature output rectangular pulse ,the circuit output is NPN open collector output type ,the output of this type can and with internal pull-up resistor is directly connected MCU or PLC ,such as 51 single or Mitsubishi PLC (PLC input mode should be connected to 0V switch function).

Note:

If the encoder is not connected to the device can not be directly oscilloscope oscilloscope (open collector output without pull-up resistor when there is no voltage output) If you want the oscilloscope in AB two-phase output with two pull-up resistors.

Wiring Output:

A phase, B phase, Vcc positive supply, V0, the shield wire.

Connection:

Green = A phase, white = B phase, red = power +, black = power - Note: AB two -phase outputs must not be connected directly to VCC, otherwise, they will burn the output transistor.

Package content

1 x 600P/R Incremental Rotary Encoder