PrimoChill System Reboot - Cooling Loop Treatment

Description

Primochill System Reboot was created to address the need to prepare/clean existing cooling loops AND be able to clean out old dyes that may have leached onto components during previous usage. Similar to Sysprep this flush style solution will cleanse out any debris/residue leaving your water cooling loop clean, clear, pristine and ready for any type of coolant. The beauty of ReBoot is it s ability to pull color from stained components.

Specifications

Bottle Size: 15ml

Dosage: Mix with 1 Gallon of DI or distilled water

Shelf Life: 2 Years, Unopened

Compatibility: ReBoot is compatible with rigid and flexible tubing of all sizes.  It is safe to use on rubber, plastics and acrylics

Included Parts: 1x 15ml Bottle of ReBoot (makes 1 gallon of coolant)

Instructions
1.Double-check connections to ensure loop is "closed". No Leaks!
2.Empty bottle of ReBoot into 1 US Gallon of fresh DI or Distilled water, shake for 30 seconds
3.Fill loop with treated solution and be sure to remove as many air bubbles as possible.
4.Start pump and begin circulating the treated solution.
5.Run solution for at least 24 to 48 hours to ensure loop is properly flushed and treated. ReBoot is not an effective final coolant and should be replaced with coolant before any extended use of computer.
6.Drain System. Inspect drained solution for debris or foreign particles. Repeat flush if needed.
7.Fill system with fresh DI or distilled water and flush thoroughly to remove ReBoot solution checking for foam.
8.Drain system.**.
9.Fill loop with your choice of coolant and begin water-cooling.
** Reboot needs to be flushed from the system until no foam is seen and water runs clear

Warnings

Do not mix with any pre-mixed coolants.

PrimoChill is not responsible for any hardware damage. Use at your own risk.