HOBBYMATE Brushed F3 Mini Flight Controller for Micro FPV Quadcopter Support 1-2S lipo, Compatible DSM2/DSMX S.Bus PPM Radio Receiver

Description

Important remind:
Hold the boot button down then plug the board in keep button held down all the way through flashing firmware make sure you select right firmware should have directions with what firmware to flash

Quad Ready - Your Aircraft, Your Choice.
With an integrated (4) ESC s, the HOBBYMATE Brushed F3 Mini FC provides epic levels of flexibility that offers you the choice to choose a quad layout for your aircraft of choice.

5V 400-500mA Built In BEC - Power Awaits.
No need for a separate power source - the HOBBYMATE Brushed F3 Mini FC simplifies everything with built in 5V power to take care of all the ancillary devices you need to fly. VTx, camera, LED lights or Rx.

Choose either power by 1s or 2s lipo battery, get more powers on your quad and bounce with ease.

Specification:

- Dimension: 26mm*21mm
- Thickness: 1.2mm
- Weight: 3g

Notice:

Before applying power, pay attention to the battery voltage selection.
The default Setting is 2S (8.4 V); When using 1S (4.2v), first need to disconnect the short contacts 1S, and then put the two pads on the 2S.

Important Note: Short Circuit 3 pads same time will permanently damage the FC

Receiver Connections:

1. DSM receiver: DSM/DSM2/DSMX Receive connect to GND, 3.3V, UART2-RX. Enable Seria_RX for UART2 and Set Receiver mode RX_SERIAL ,Select Spektrum1024(DSM/DSM2) or Spektrum2048(DSMX) in Cleanflight or Betaflight configurator.

2. Futaba and other S.BUS receiver: Connect to GND, 3.3V, UART2-RX. Then Enable Seria_RX and Set Receiver mode RX_SERIAL ,Select Sbus signal in Cleanflight or Betaflight configurator.

3. PPM receiver: Connect to GND, 5V, PPM。 Then set Receiver mode to RX_PPM in Betaflight configurator.