Fan Thermostat Temperature Switch Engine Cooling Sensor Relay Kit 185 to 200 Degree

Description

Note:For the two red wires,please connect the long red wire to the fan and the short red wire to the battery.

1.Mount the relay under the hood in a convenient location as to the fan as possible.
Notice:Don t use the teflon tape or thread compoud on the thermostat or adaptor.For proper operation,the thermostat must ground threough the threads to the engine and the engine must be ground.
2.Install thermostat into the head or intake manifold.Route the black wire to thermostat and cut to length.Crimp the red terminal onto the black wire and attach to thermostat.
3.Route and connect the red wire to the fan "+" terminal or power wire coming from the fan motor printed "to electric fan".
4.Mount the circuit breaker provided in a convenient location as close as possible to whichever power source(battery or large terminal on the starter solenoid)you are using for the fan relay.
5.Neatly route the red wire from the relay to one side circuit breaker installed in step 5. Cut to length and install using a small yellow ring terminal .With another small yellow ring terminal take the remaining red wire and connect the unused post on the circuit breaker to the battery source.This wire is printed"to battery/constant hot"
6.Route the brown wire to the ignition switch or the fan switch whichever is more convenient.

Installation tips:
1.Turning off the engine, replace the new cooling fan temperature switches after the water in engine radiator cooled to the room temperature.
2.Avoid the external high heat source after installation.
3.Avoid sprinkling water on surrounding auto parts during the installation.

Specification:
Voltage: 12V DC
Material: Plastic and Metal
Package Box Size: 13 x 9 x 7cm (L x W x H)
Cable Length: approx.165cm
Quantity: Pack of One Set

Package include:
1× Fan Temperature Switch