Desoldering pump desoldering wick Jajaplus Solder Braid and Solder Sucker Desoldering Vacuum Pump Solder Removal Tool (Gold)

Description

What  was this ?

It was a solder remove tool kit  for soldering jobs

What were them for ?

Clean the extra solder when you do soldering projects and solder braid will help clean spare solder on the pin away to avoid short circuit, especially in small, hard to reach areas

tips on solder wick:

1. Make sure you are applying the iron to the wick, not the item to be soldered. Use the iron to depress the wick on to the workpiece.

2. This wick is pre-treated, but you can apply a light coat of flux to the wick if yours is old or otherwise dried out.

3. This is an especially tight braid. I find it helpful to splay the ends of the wick a bit just to loosen it up. This seems to get the capillary action going quicker.

4. If the solder isn t coming off as clean as you would like, you can try applying more solder, which will give the solder more momentum and might be the extra push you need.

5. You might want to wear an agile glove, like Mechanix, since the wick gets very hot within several inches of the tip. Otherwise you have to hold the wick further from the tip, or else by the spool or with a tool, which might not give you the control you need for delicate work.

How to operate it?

1. Press down on the suction rod until you hear a tick

2. Soldering the soldering iron with a soldering iron, the suction tin at the solder point, press the suction tin button to suck the net excess solder or small components

3. Interface rubber seal design to prevent leakage, strong suction, the head can be rotated down to facilitate cleaning

4. nozzle close to the soldering iron will not melt, if not a clean, can be used repeatedly. 

Notice:

When you trigger the sucking function it jumps off  was the normal phenomenon， watch some of video on how to use the solder pump and wick before working.