Adafruit 1.2" 4-Digit 7-Segment Display w/I2C Backpack - Red [ADA1270]

Description

What s better than a single LED? Lots of LEDs! A fun way to make a numeric display is to use a 4-digit 7-segment display . LED matrices like these are multiplexed - so to control all the seven-segment LEDs you need 14 pins. That s a lot of pins, and there are driver chips like the MAX7219 that can control a matrix for you but there s a lot of wiring to set up and they take up a ton of space. Here at Adafruit we feel your pain! After all, wouldn t it be awesome if you could control a matrix without tons of wiring? That s where these adorable LED matrix backpacks come in. We have them for a variety of 8x8 and 7-segment displays. They work perfectly with the displays we stock in the Adafruit shop and make adding a bright display trivial.

The backpacks use a driver chip that does all the heavy lifting for you: They have a built in clock so they multiplex the display. They use constant-current drivers for ultra-bright, consistent color (the images above are photographed at the dimmest setting to avoid overloading our camera!), 1/16 step display dimming, all via a simple I2C interface. The backpacks come with address-selection jumpers so you can connect up to eight 7-segments (or a combination, such as four mini 8x8 s and four 7-segments, etc) on a single I2C bus.

The product kit comes with:

• A fully tested and assembled LED backpack
• Ultra-bright 4-digit 1.2" tall red seven-segment display
• 5-pin header

A bit of soldering is required to attach the matrix onto the backpack but its very easy to do and only takes about 5 minutes.

Of course, in classic Adafruit fashion, we also have a detailed tutorial showing you how to solder, wire and control the display . We even wrote very nice libraries for the backpacks so you can get running in under half an hour, displaying numbers on the 7-segment for either Arduino or Raspberry Pi. If you ve been eyein